Your Local
Distributor of

Part Search
Hint: Replace all spaces with a dash for a more accurate search
PDF Catalogs
Universal Extrusions
Installation Guides
Part Location Diagrams
Convertible Tops
Roof Rails
Pillar Post Seals
Door Seals
Quarter Window Seals
Trunk Seals
Rubber Bumpers
Upcoming Car Shows


Home Products About Us
Truck Seals

GENERAL HINTS: Proper fit and function of this trunk weatherstrip extrusion depends upon the correct installation (Figure 9A). Do not use your old flattened strip as a guide. Read the entire instructions here before beginning.

A) PREPARATION: Compare your old seal to the new one to make sure that the new seal will do the job. Remember, old seals are flat and your new sponge rubber is very forgiving in the case of slight difference in shape. Make sure you take note of which side of your strip faces toward the trunk!

B) REMOVE OLD SEAL: Apply liberal amounts of a release agent as you pull until you have removed all weatherstripping. Make sure any old adhesive, debris or rubber is removed with a scraper and even vacuumed if necessary.

C) ADHESIVE BEAD: Check your trunk lid alignment and then run a bead of adhesive inside the groove as you install the strip.

D) INSTALL WEATHERSTRIP: Start at the center above the lock cylinder and begin to insert your new weatherstrip. Fold your strip in half and start with the half-way point. Make sure both inside and outside edges are tight and sealed.




E) GLUE AS YOU GO: Start about 8 inches from the center and begin to glue around each side as you go until you get to about 8 inches from the end. Carefully cut the ends squarely to match together, allowing a 1/4 inch to overlap. At this seam, apply adhesive to the trunk channel and a small amount to the ends of the strip. Hold the ends together for a moment and then insert. Close your trunk and open it, making sure no glue oozes out and shows. Wipe up any excess glue immediately.




Fixit Rubber Parts L.L.C.
W6903 Kenyon Rd..
Oakfield, WI 53065
Toll Free Phone Sales: (866) 654-4480 Phone: (920) 583-4106
Fax: (920) 583-4106
or Click here to contact us

Copyright 1998-2007 Fixit Rubber Online

Web site designed and created by The CobblinGoblin L.L.C