Your Local
Distributor of

Part Search
Hint: Replace all spaces with a dash for a more accurate search
PDF Catalogs
Universal Extrusions
Installation Guides
Part Location Diagrams
Convertible Tops
Roof Rails
Pillar Post Seals
Door Seals
Quarter Window Seals
Trunk Seals
Rubber Bumpers
Upcoming Car Shows


Home Products About Us
Rubber Bumpers

GENERAL HINTS: Popping out old, hard and cracked rubber bumpers takes little more than a screwdriver and some careful prying. To prevent scratching the surface, you may want to use another item to cushion the screwdriver as you pry.

 If a plastic anchor breaks off and remains in the hole, try poking it through or even carefully using a tiny drill to remove it.

DOOR BUMPERS: Align anchors with door holes and push in (Figure 6A). You may use a light lubricant, such as soap, and the handle end of a small screwdriver to push the carrot in solidly.

TRUNK BUMPERS: Your bumpers will become flat and inefficient with age. Just line up your new set and push into the hole, using some lubricant and a twisting action.





HOOD BUMPERS: Both hood bumpers and adjustable hood bumpers are important for a proper hood fit. Match the fender slots and bumper anchors and slide the bumper into the key hole slot. Adjustable bumpers should already be adjusted to the proper height of your hood. If not, screw the bolt up or down for a flush hood.

GLOVE BOX CONSOLES: These tiny bumpers help prevent glove box or console noise and help keep your car from the damage associated with opening and closing these small doors. Use pliers to pull the old ones out and push in the new ones. Pulling a tail from the back is also helpful (Figure 6B).




Fixit Rubber Parts L.L.C.
W6903 Kenyon Rd..
Oakfield, WI 53065
Toll Free Phone Sales: (866) 654-4480 Phone: (920) 583-4106
Fax: (920) 583-4106
or Click here to contact us

Copyright 1998-2007 Fixit Rubber Online

Web site designed and created by The CobblinGoblin L.L.C