Your Local
Distributor of

Part Search
Hint: Replace all spaces with a dash for a more accurate search
PDF Catalogs
Universal Extrusions
Installation Guides
Part Location Diagrams
Convertible Tops
Roof Rails
Pillar Post Seals
Door Seals
Quarter Window Seals
Trunk Seals
Rubber Bumpers
Upcoming Car Shows


Home Products About Us
Pillar Post Seals

A) PREPARATION: Carefully remove the old seals from your car, using a release agent if necessary. Remove all old rubber pieces from the retainer channel, using a wire brush if necessary. Wipe clean.

 Watch out for the sharp edges! You may put a strip of masking tape down the sides to help prevent scratches.

B) LUBE UP: Using a clean rag, cover the entire strip with lubricant for easy installation and adjustment.

C) INSTALL BOTTOM END: Starting at the bottom (Figure 7A 7B), set and install the molded end, inserting new pins into holes. Apply a very tiny amount of glue to a clean spot (clean up any lubricant) on the back side of the end to help hold it in place.

D) COMPLETE INSTALLATION: After the bottom end is installed and all pins are in place, apply a small amount of waterbased lubricant to both the retainer channel and the back side of the seal. Now carefully pry the flange into the retainer channel using a hard squeegee (Figure 12B).

E) ADJUSTMENTS: The exact final length can be adjusted by pushing and compressing the rubber.

 The lubricant should allow the rubber to slide easily. Repeat this procedure for the other side.

F) ADD ADHESIVE: If the ends seem to slip, clean off any lubricant and then apply only a tiny amount of adhesive to help hold the ends.

A CUSTOM FIT! Your new seal is made from our great SUPERSoft sponge. It will adjust slightly in profile after a few days to provide excellent sealing qualities. This will be done while your window is compressed against the new seal.



Fixit Rubber Parts L.L.C.
W6903 Kenyon Rd..
Oakfield, WI 53065
Toll Free Phone Sales: (866) 654-4480 Phone: (920) 583-4106
Fax: (920) 583-4106
or Click here to contact us

Copyright 1998-2007 Fixit Rubber Online

Web site designed and created by The CobblinGoblin L.L.C